Wireless-G PrintServer with Multifunction Printer Support
20. The PrintServer is now connected to your wireless network.
Next you need to install the PrintServer driver on your computer. Click Set up Computer, and go to
"Chapter 4: Installing the PrintServer Driver".
About the New Program Icons
After you have run the Set up PrintServer Setup Wizard, the PrintServer program icons will appear in the Start
menu. To access these icons, click Start. Select Programs. Then select Linksys MFP Network Adapter. You
will have four options available:
• To uninstall the PrintServer from your computer, click Uninstall.
• To run the wizard that sets up the PrintServer driver, click Diagnostic. Refer to "Chapter 4: Installing the
PrintServer Driver" for details.
• To access the diagnostic utility, click PrintServer Utility. For more information, refer to "Chapter 5: Using the
Diagnostic Utility".
• To run the wizard that sets up the PrintServer, click Setup Wizard. Refer to the previous section in this
chapter, "Installation".
Chapter 3: Installing the PrintServer Using the Setup Wizard
About the New Program Icons
Figure 3-23: Continue to Set up Computer
Figure 3-24: New Program Icons
16