Linksys DSHSNMP User Manual page 34

Trap Receiver Setup
If you are running performance tests on your managed stack of
hubs, you can configure your SNMP module to send the test
results to a specific IP address on the network. Trapping is
useful for determining the cause of collisions, data loss, and
isolating and studying any number of network or networked
application performance statistics.
The SNMP module's Trap Receiver menu allows you to set the
IP address that will receive all of the information collected
when the trap is performed. You can also view the trap receiv-
er's community name, and you can view the status of the node
at the specified IP address.
The StackPro II SNMP application allows you to set up to
four trap receivers on your local network.