Linksys DSHSNMP User Manual page 11

OPERATOR
The operator can set only the variables under the port-
configuration menu. All other variables are only read-only.
The default password for this level is "operator"
USER
The user level offers read-only access to the hub's settings.
The default password for the user level is "user"
You should change all three of the SNMP module's passwords
under the "Change Password" sub-menu later.
8. Enter the manager password. You will see a command
menu.
9. The first thing you should do is change the hub unit's IP
address. The default address for the hub is 192.168.0.1.
Press 2 to get to the "Protocol Configuration" menu. Give the
hub a unique IP address in this format: nnn.nnn.nnn.nnn
The values for each variable in the address should fall
between 0 and 255. Be sure that the IP address fits into the
Subnet addressing scheme of your network. You can also set
the Subnet Mask and the Routing Address from the "System
Setting" menu.
10. After the IP address has been set, you can manage your
hub by using a Network Management application (such as HP
OpenView) or a web browser from anywhere on the network.
Any browser you use must support frames, Java, and HTML
3.2 or higher.
8