Enable/Disable Ports - selection [3]
The enable/disable sub-menu will allow you to partition par-
ticular ports in the stack from the rest of the network.
Network Management Module Setup
--------------------------------------------------
Port
[1][2][3][4][5][6][7][8][9][10][11][12][13][14][15][16]
Status [E][E][E][E][E][E][E][E][E][E][E][E][E][E][E] [E]
--------------------------------------------------
Port
[17][18][19][20][21][22][23][24]
Status
[E][E][E][E][E][E][E][E]
[E] Enable
[D] Disable
Select one port number .. <1..24, X for Exit>
By keying in the port ID number of the particular port on the
hub, you can toggle the port's partition status. If you are using
fiber optic distance extender modules, they will appear at the
end of the port list. For example, if you are using a 24-Port
StackPro II hub, the fiber module will be listed as port 25.
Press X to return to the Port Management menu, and then X
again if you want to return to the main menu.
Port Management/Partition
19