Linksys DSHSNMP User Manual page 10

Run a terminal program on your PC - for example, run the
HyperTerm program under Windows 95/98 - and set the fol-
lowing parameters
Baud Rate:
Data Bits:
Parity:
Stop Bits:
Flow Control:
4. Connect your PC to the SNMP module using one of the
PC's active serial ports. Directly connect them using a DB-9
male to DB-9 male serial cable. Do not use a null modem
cable.
5. Turn on the hub.
6. You will see diagnostic messages in the terminal window.
The hub is running a self-test. Please wait for it to finish, and
watch to make sure that the hub passes all of the tests.
7. After the hub finishes its self-test, you will notice that the
LEDs on the hub(s) are displaying management information.
On the hub that is managed, the MNGMNT light will be on.
You will be prompted to enter a password. There are three
access levels. Your access to the hub's management capabili-
ties will be determined by the password that you give.
MANAGER
The manager has access to all functions on the hub and can
configure any of the hub's settings. The default password for
this level is "manager"
38400
8
None
1
No
7