Linksys DSHSNMP User Manual page 21

Port Speed - selection [2]
The port speed sub-menu will allow you to view and set the
speeds of every port in the stack.
Network Management Module Setup
--------------------------------------------------
Port
[1][2][3][4][5][6][7][8][9][10][11][12][13][14][15][16]
Status [A][A][A][A][A][A][A][A][A][A][A][A][A][A][A] [A]
--------------------------------------------------
Port [17][18][19][20][21][22][23][24]
Status [A][A][A][A][A][A][A][A]
[A] Auto-Sensing 10BaseT/100BaseTX (10Mbps or 100Mbps)
[F] 100BaseTX only (100Mbps)
[E] 10BaseT only (10Mbps)
Select one port number .. <1..24, X for Exit>
Each port can be set to run in auto-sensing (10/100) mode
[A], 10Mbps only [E], or 100Mbps only [F] modes. Press the
ID number of the port to select it, and then select the value
(denoted by A, F, or E) to set the port's speed. If you are using
fiber optic distance extender modules in any of your hubs,
they will appear at the end of the port list. For example, if you
are using a 24-Port StackPro II hub with a fiber module, the
fiber module will be listed as port 25. The modules are fixed
at 100Mbps and cannot be set to different speeds.
After you have finished your port management commands,
press X to return to the Port Management menu. Here you can
select another hub in the stack and manage more ports, or you
can press X again to go to the main menu.
Port Management/Speed
18