Lexmark Optra 1200 Setup Manual page 54

Note:
Depending on your
printer model, you may already
have an Ethernet INA installed in
connector 1.
Connector 2
Connector 1
48
Install memory and network options
Installing
You can install the following adapters in your printer:
adapters
An internal network adapter (INA), such as the
MarkNet
network (LAN). MarkNet S adapters support the follow-
ing topologies:
The tri-port adapter provides connectors for the following:
The parallel port adapter provides an additional
parallel port. Its 1284C connector requires a 1284 A–C
cable. You can purchase a 3 m (9.8 ft) cable meeting these
specifications from Lexmark.
Refer to the documentation that came with your adapter
for more information.
There are two adapter connectors on your system board:
connector 1 and connector 2. Both connectors support net-
work, tri-port, and parallel port adapters.
You can install up to two adapters in any combination. If
you install two tri-port adapters, your printer can support
two serial ports (but only one receive-only fax port), one
LocalTalk port, and one infrared port.
If you are installing one adapter, install it in connector 1.
You can then easily install a second adapter in connector 2.
If you already have an adapter installed in connector 2
and you want to install a second adapter, you must first
remove the adapter in connector 2, and then install the
adapters in connector 1 and connector 2 in sequence.
• Internal network adapter
• Tri-port adapter
• Parallel port adapter
TM
S, lets you connect the printer to a local area
• Ethernet 10BaseT and 10Base2
• Ethernet 10/100BaseTX
• Token-Ring
• Serial interface (RS-232C or RS-422), which can also
serve as a receive-only fax port
• LocalTalk network
• An infrared adapter