Appendix Cas-Interface Terminology And Abbreviations - Omron CQM1-ARM21 Operation Manual

AS-Interface terminology and abbreviations
Symbols and abbreviations
APF
APM
APO
AS-Interface
CB
CD
CDI
EB
IDI
LAS
LDS
LPS
ODI
PB
PCD
PI
PP
PSK
ST
TBit
0x00
AS-Interface Glossary
active slave
address assignment
address
AS-Interface
AS-Interface cycle
AS-Interface input
AS-Interface line
AS-Interface network
AS-Interface output
64
Appendix C
AS-Interface Power Fail
Alternate Pulse Modulation
AS-Interface Power On
Actuator Sensor Interface (the term ASI is used, but not officially approved)
Control Bit
Configuration Data
Configuration Data Image
End Bit
Input Data Image
List of Active Slaves
List of Detected Slaves
List of Projected Slaves
Output Data Image
Parity Bit
Permanent Configuration Data
Parameter Image
Permanent Parameter
Phase Shift Keying
Start Bit
Bit time
hexadecimal representation of binary values, e.g.: 0x1F = 31 , 0xF = 15
A slave connected to the AS-Interface line and capable to communicate properly.
Replacement of the existing address of the AS-Interface slave with a new
address.
An address out of the address space of the AS-Interface slaves (0...31).
Actuator Sensor Interface: a set of interfaces and a serial communication method
to connect low-voltage switch gear, control gear, and other simple elements with
a controlling device.
A set of up to 33 transactions. A transaction may - in case of detected failure -
include one message retransmission.
Physical or logical slave input port.
Two-wire line for transferring information and power to the AS-Interface slaves
and the AS-Interface master.
Network composed of an AS-Interface control circuit, interfaces and switching
elements, e.g. master, slaves, power supply, cable, taps.
Physical or logical slave output port.