Universal Audio Ampex ATR-102 Manual page 72

Recirculation allows both positive and negative values. The polarity refers to
the phase of the delays as compared to the original signal. If Recirculation dis-
plays a positive value, all the delays will be in phase with the source. If it dis-
plays a negative value, then the phase of the delays flips back and forth be-
tween in phase and out of phase.
This low pass filter reduces the amount of high frequencies in the signal. Turn
Damping Knob
down this control to reduce the brightness. Higher values yield a brighter sig-
nal. Damping also mimics air absorption, or high frequency rolloff inherent in
tape-based delay systems.
Wet/Dry Mix This control determines the balance between the delayed and original signal.
Knob
Values greater than 50% emphasize the wet signal, and values less than 50%
emphasize the dry signal.
Wet/Dry Mix allows both positive and negative values. The polarity refers to
the phase of the delays as compared to the original signal. If a positive value
is displayed, then all the delays will be in phase with the source. With a neg-
ative value, the delayed signal is flipped 180 degrees out of phase with the
source.
Sets the stereo position for the left channel, allowing you to adjust the width
L-Pan Knob
or balance of the stereo signal. For a mono signal, set both the L-Pan and R-
Pan to the left.
Sets the stereo position for the right channel, allowing you to adjust the width
R-Pan Knob
or balance of the stereo signal. For a mono signal, set both the L-Pan and R-
Pan to the left.
Enable/Bypass Enables or disables the Reflection Engine. You can use this switch to compare
Switch
the RS-1 settings to the original signal or bypass the entire RS-1 section to re-
duce UAD DSP load (load is not reduced if UAD-2 DSP LoadLock is enabled).
Adjusts the relative output of the plug-in.
Output Knob
UAD Powered Plug-Ins Manual - 72 - Chapter 5: CS-1 Channel Strip