Universal Audio Ampex ATR-102 Manual page 125

Dry/Wet
This control uses a logarithmic scale to provide increased resolution when se-
lecting lower values. When the slider is in the center position, the value is
15%.
Note:
Wet Solo The Wet Solo button puts the EMT 250 into "100% Wet" mode.
When Wet Solo is on, it is the equivalent of setting the Dry/Wet
control to 100% wet.
Wet Solo defaults to On, which is optimal when using the EMT 250 in the
"classic" reverb configuration (placed on an effect group/buss that is config-
ured for use with channel sends). When the EMT 250 is used on a channel in-
sert, this control should be deactivated.
Note:
Noise
Noise is active when the yellow LED is illuminated; it is enabled by default.
Click the LED to change the setting.
The Noise parameter is unique to the UAD EMT 250 plug-in. Noise is dy-
namic to the response of the effect processing, and the noise level differs from
program to program. The noise floor of the hardware EMT 250 may seem a
bit high when compared to modern digital processors, but it adds to the EMT
250's quirky character.
UAD Powered Plug-Ins Manual
If Wet Solo is active, adjusting Dry/Wet will have no effect.
Wet Solo is a global (per EMT 250 plug-in instance) control.
When Noise is active, the noise characteristics of the original
hardware unit are fully intact. Disabling Noise eliminates the
modeled noise characteristics for quieter operation.
The Dry/Wet slider control determines the
balance between the original and the pro-
cessed signal. The range is from 0% (dry,
unprocessed) to 100% (wet, processed sig-
nal only).
- 125 - Chapter 10: EMT 250 Electronic Reverberator