Universal Audio Ampex ATR-102 Manual page 100

Bypass/Tranny
Tranny (green LED)
The Tranny processor is active in this mode (see
page 95
quency "rounding," low order clipping, intermodular distortion and transient
clipping. On FATSO Sr., the Tranny amount can be set with the Tranny Level
control
Note:
when DSP LoadLock is disabled. If DSP LoadLock is enabled (the default set-
ting), disabling Tranny will not reduce DSP usage.
Tranny Off (red and green LED's off)
In this mode, the Tranny processor is inactive but the other processors are ac-
tive. This mode requires less UAD DSP than when Tranny is active.
Bypass (red LED)
All FATSO controls and processing for the channel are inactive in this mode.
Note:
UAD DSP usage when bypassing both channels of the FATSO, use the Power
switch instead
Output
UAD Powered Plug-Ins Manual
This black button is a multifunction control. Clicking the button re-
peatedly cycles through Tranny, Bypass, and Tranny Off modes.
The currently active mode is indicated by the adjacent LED's.
for a detailed description of this mode). The Tranny circuit adds fre-
(page 105).
Disabling Tranny will yield a significant reduction in UAD DSP usage
UAD DSP load is not reduced in Bypass mode. If you want to reduce
(page 102).
The Output knob controls the signal level that is output
from the plug-in.
Note:
pass/Tranny" on page
This control has no effect when Bypass
100) is active.
- 100 - Chapter 8: Empirical Labs EL7 FATSO
"The Tranny Processor" on
("By-