Universal Audio Ampex ATR-102 Manual page 31

Thru
Thru is a processor bypass control. When Thru is enabled, all controls are in-
active, emulation processing is disabled, and DSP usage is reduced.
Thru behavior is similar to that of the OFF position in the POWER control
(page
Meters indicate signal levels at the input of the plug-in prior to processing.
Note:
LoadLock is enabled (the default setting), activating Thru will not reduce DSP
usage.
When the secondary controls panel is closed
Tape Reels
Animation
(Figure 1 on page
cal tape reels "spin" if the DAW transport is
running. The tape reels animation can be dis-
abled by clicking the capstan graphic.
Re-clicking the capstan will re-start the animation.
The "spin state" is saved until it is changed again.
Note:
plug-in must be configured as a "tempo-based effect" for reels animation.
UAD Powered Plug-Ins Manual
27), except that the
DSP usage is reduced only when DSP LoadLock is disabled. If DSP
20), by default the graphi-
Spinning reels automation is not supported in all hosts. In Sonar, the
Meters are still active in Thru mode. In this state, the
- 31 -
Click capstan
to start/stop
reels animation
Chapter 2: Ampex ATR-102