Universal Audio Ampex ATR-102 Manual page 401

• Gang Controls is a static control without the ability to make relative offsets.
• If Gang Controls is enabled when Auto Cal is enabled, any adjustments
• When Gang Controls is enabled, there are no audible or visual changes to
• When Gang Controls is enabled and a Studer A800 settings preset is
Calibration Refer to
Controls
Repro EQ controls. These controls are automatically adjusted when
is active, or they can be manually modified as desired.
The "flat" calibrated position for these controls is determined by Tape Type
and Tape Speed; therefore the available ± range for these controls is depen-
dent on the current calibration.
Tip:
pro EQ controls will return that parameter to the calibrated value.
Note:
Cal
another control is modified.
UAD Powered Plug-Ins Manual
Disable Gang Controls if offsets between the same control within different
instantiations is desired.
made to Tape Type, Tape Speed or Emphasis EQ causes the
Controls to be automatically adjusted for all instantiations. However, if the
Tape Type, Tape Speed or Emphasis EQ values do not already match be-
tween instantiations before Gang Controls is active, the resulting calibrated
values may not match either.
the other Studer A800 instantiations until a control is actually changed.
loaded via the UAD Toolbar, the loaded parameter settings are pushed to
all Studer A800 instances.
Figure 129 on page 402
Clicking the text label for any of the HF Record EQ, Bias, and Sync/Re-
When making manual calibration settings, consider disabling Auto
(page 400) so the manually calibrated settings are not accidentally lost if
for the HF Record EQ, Bias, Sync EQ, and
- 401 -
Calibration
Auto Cal
Chapter 45: Studer A800