Universal Audio Ampex ATR-102 Manual page 185

Like the original hardware, increasing the Frequency value (rotating clock-
wise) actually lowers the target frequency ("increases the low end"). Changes
to this setting are heard only if Amplitude is set above zero.
Note:
trary and do not reflect a particular frequency value.
Center The two Center switches define the active center frequency
of the effect, which in turn determines the available fre-
quency range. The four available center frequencies, and
resulting frequency ranges, are shown in
A switch is "ON" when its LED is red. A green LED indi-
cates the switch is "OFF."
Table 16. Center Switch Frequency Values
"40" Button LED
Flat The EQ circuitry is bypassed when Flat is enabled (red
LED); the circuit is active when Flat is disabled (green LED).
When Flat is on, the dry signal path of the hardware is still
being modeled and DSP is used. For true bypass, use the Power switch.
Power
abled). Power is useful for comparing the processed settings to the original
signal.
UAD Powered Plug-Ins Manual
The control values for Frequency, which range from 0 – 10, are arbi-
"100" Button LED
Green Green
Red Green
Green Red
Red Red
Power is the plug-in bypass control. When set to OFF,
emulation processing is disabled, the LEDs are dimmed,
and DSP usage is reduced (if UAD-2 DSP LoadLock is dis-
Table 16
Center Frequency (Hz)
40
42
100
200
- 185 -
below.
Frequency Range (Hz)
18 – 60
20 – 62
50 – 180
100 – 305
Chapter 19: Little Labs VOG