Carrier Sub-Assembly - JLG 600A Service And Maintenance Manual

Carrier Sub-Assembly

1. Apply a coat of grease or petroleum jelly to cluster gear
bore.
2. Place sixteen needle rollers into cluster gear bore.
3. Place spacer washer into opposite side of cluster gear
and against needle rollers.
3121201
SECTION 3 - CHASSIS & TURNTABLE
4. Place second set of sixteen needle rollers into cluster
gear.
5. Apply grease or petroleum jelly to the tang side of two
thrust washers. Place thrust washers against bosses in
carrier with washer tang fitting into slot in carrier
outside diameter.
NOTE: Some old style carriers will not have slots and tangs should
be located inside boss relief.
6. While keeping thrust washers in place, slide cluster gear
into carrier with the larger gear on the side with the
small pin hole.
3-61