JLG 600A Service And Maintenance Manual page 75

SECTION 3 - CHASSIS & TURNTABLE
3C. Needle Bearing
3F. Planet Gear
Figure 3-11. Planet Gear Subassembly
3-16
1. Using a 1/8 in. (3.175 mm) diameter punch, drive the roll
pin (4G) into the planet shaft (3E) until it bottoms
against the carrier (3A).
2. Using a soft face hammer, tap the planet shaft (3E) out of
the carrier (3A).
3. Using a 1/8 in. diameter punch, drive the roll pin (4G)
out of the planet shaft (3E).
NOTE: The roll pins (4G) should not be reused when reassembling
the unit.
4. Slide the planet gear (3F) and the two Thrust Washers
(3B) out of the carrier (3A).
5. Remove the 14 needle bearings (3C) from the bore of
the planet gear (3F).
6. Repeat steps 1 through 5 for each of the two remaining
planet gears.
3121201