JLG 600A Service And Maintenance Manual page 100

19. Turn the housing on its side and remove the cylinder kit
assembly (31). Set the assembly aside, being careful not
to scratch the running surface.
NOTE: Grooves on the surface of the cylinder kit identify its dis-
placement:
Table 3-3. Displacement Identifiers
# of Grooves
1
2
3
31. Cylinder Kit Assembly
Figure 3-28. Cylinder Kit
3121201
Frame L Frame K
25 38
30 45
35 -
31
SECTION 3 - CHASSIS & TURNTABLE
20. Turn the housing over and remove the snap ring (32)
retaining the shaft seal and support washer. Remove the
support washer (33) and carefully pry out the shaft seal
(34). Discard the seal.
TO AVOID DAMAGING THE SHAFT DURING SEAL REMOVAL. INSTALL A LARGE
SHEET METAL SCREW INTO THE CHUCK OF A SLIDE HAMMER. DRIVE THE
SCREW INTO THE SEAL SURFACE AND USE THE SLIDE HAMMER TO PULL THE
SEAL.
32
33
34
32. Snap Ring
33. Support Washer
34. Shaft Seal
Figure 3-29. Shaft Seal
3-41