24. A usual commercial bearing puller is used to
disassemble the external bearing ring of the taper roller
bearing inside the port plate. Take care not to damage
the surface of the port plate.
25. The spring has additional pretension while you
disassemble the three pressure pins inside the cylinder.
3121201
SECTION 3 - CHASSIS & TURNTABLE
Assembly Notes
1. Measurement of the taper roller bearing pretension.
2. Note that there is a correct connection of the piston rod
and the swash plate.
3. Pumps clockwise driven must have a position to the
valve plate 4 degrees out of center in the same direction
de-centered like drive direction. (Note spare parts exist
as cw and ccw valve plates).
3-35