Canon imageCLASS D600s Service Manual page 128

CHAPTER 3 INSTALLATION
2 Unpacking and Installing the Machine
2.1 Before Starting the Work
Go through the following before starting to install the machine:
If the machine is moved from a cold to warm place for installation, conden-
sation can develop in its pickup/feeding assembly, causing image faults. To
avoid the condensation, leave the machine alone unpacked for 1 hr or more
so that it will be fully used to the room temperature.
(The term condensation refers to the development of drops of water on a
mental surface when it is brought from a cold to warm place, occurring as
the result of rapid cooling of vapor in the air.)
2.2 Installation Procedure
Install the machine in the following order; for details, see the appropriate sections that fol-
low; after installation, be sure to clean up the area around the machine:
1. unpacking
2. fitting the cartridge into the machine
3. putting paper in the cassette
4. putting paper in the manual feed tray
5. fitting the delivery tray
6. connecting the interface cable (if equipped with printer functions)
7. connecting the modular cable (if equipped with fax functions)
8. connecting the power cord
9. checking the copy images
10. setting the printer functions (if equipped with printer functions)
11. setting the fax functions (if equipped with printer functions)
3-2
COPYRIGHT © 2001 CANON INC.
Chapter3.p65
CANON imageCLASS D600s/PC1060s/iR1200s REV. 0 SEPT. 2001
2 8/26/01, 3:43 PM