Table of Contents
Advertisement
#1 SSW-SW03: echo remedy setting
Bit
0
not used
1
echo product tone in high-speed
transmission
2
not used
3
not used
4
not used
5
not used
6
not used
7
tonal signal before transmission
of CED signal
[Bit 1]
Use it to specify whether or not to transmit an echo protection tone for high-speed trans-
mission V.29 (9600 or 7200 bps; modem signal).
If an error occurs often because of a line condition at time of transmission, set it to '1'. If
set to '1', unmodulated carrier will be transmitted as a sync signal before transmission of an
image for about 200 msec.
The following error codes are associated with a line condition at time of
transmission:
Memo
##100, ##104, ##281, ##282, ##283, ##750, ##755, ##760, ##765
[Bit 7]
Use it to specify whether or not to transmit a 1080-Hz total signal before transmission of
the CED signal. Set it to '1' if an error occurs often because of an error at time of reception.
The following error codes are associated with an echo at time of reception:
##005, ##101, ##106, ##107, ##114, ##200, ##201, ##790
Memo
COPYRIGHT © 2001 CANON INC.
Chapter2.p65
Function
-
transmit
-
-
-
-
-
transmit
CANON imageCLASS D600s/PC1060s/PC1200s/iR1200s REV. 0 SEPT. 2001
31
CHAPTER 2 USING THE MACHINE
1
0
-
0
do not transmit
0
-
-
-
-
-
do not transmit
0
8/26/01, 3:42 PM
Factory setting
2-31
Advertisement
Table of Contents
Troubleshooting
