Table of Contents
Advertisement
2
2. Move the upper basket to the lowest level
to reach the spray arm more easily.
3. To detach the spray arm (C) from the
delivery tube (A), turn the mounting
element (B) counterclockwise and pull the
spray arm downwards.
4. Wash the spray arm under running water.
Use a thin pointed tool, e.g. a toothpick,
to remove particles of soil from the holes.
Run the water through the holes to wash
soil particles away from the inside.
13. TROUBLESHOOTING
WARNING!
Improper repair of the appliance may
pose a danger to the safety of the user.
Any repairs must be performed by
qualified personnel.
The majority of problems that may occur
can be solved without the need to contact
an Authorised Service Centre.
Problem and alarm code
You cannot activate the appli‐
ance.
The programme does not start.
22
ENGLISH
1
Possible cause and solution
•
Make sure that the mains plug is connected to the mains socket.
•
Make sure that there is no damaged fuse in the fuse box.
•
Make sure that the appliance door is closed.
•
If the delay start is set, cancel the setting or wait for the end of the
countdown.
•
The appliance recharges the resin inside the water softener. The du‐
ration of the procedure is approximately 5 minutes.
5. To install the spray arm (C) back, insert
the mounting element (B) in the spray
arm and fix it in the delivery tube (A) by
turning it clockwise. Make sure that the
mounting element locks into place.
6. Install the cutlery drawer on the sliding
rails and block the stoppers.
Refer to the below table for information on
possible problems.
With some problems, the display shows an
alarm code.
Advertisement
Table of Contents
