Update Firmware - AVE VSI-Pro Max Operation Manual

5. PROGRAMMING
VSI-Pro Max Firmware Download Menu
This document describes the VSI-Pro Max firmware update feature. This feature allows a user to download firmware
update via the RS-232 port. The executable "bin" program is then loaded via any terminal program such as Hyper Terminal
via a PC or compatible device.
To update the VSI-Pro Max, select "Download/Upload Setup" from the main menu and the following submenu will
appear on screen. Select "UPDATE FIRMWARE" from the menu selection and follow the instructions below.
WARNING: Make sure you have the proper firmware bin file and follow the on screen instructions carefully for selec-
tion of the Update Firmware Utility will permanently erase the firmware in the unit and can not recover unless you
download the firmware.
Update Firmware of VSI-Pro Max
You have to connect the VSI-Pro Max with a Serial Program Terminal such as HyperTerminal, IC etc. But advise to
use HyperTerminal.First, you have to set the baud rate HyperTerminal to 115,200. Note: Make sure you do not have
the "Scroll Lock" turned on in Hyperterminal or errors will occur.
See PC Windows below to verify proper HyperTerminal setup.
Click File ==> Properties
You will see the configuration frame and select the proper Comport.
Click "Configure" to set the Communications settings.
Figure 190: HyperTerminal Main Menu
Verify that the correct ComPort is selected in the Connect Menu dialog box. If you are using a USB to RS-232 converter
and not sure which Comport has been assigned you can go to Control Panel, System, Hardware, Device Manager, Ports
and the USB adapter along with all other Comports available are you PC are listed so you can select the proper one.
VSI-Pro Max POS / Cash Register Interface
DOWNLOAD SETUP
UPLOAD SETUP

UPDATE FIRMWARE

EXIT
Figure 189: Update Firmware Sub-Menu
74
Figure 191: Connect To Menu