AVE VSI-Pro Max Operation Manual page 103

APPENDIX T
8. With the end catch now out away from the top cover,
slide out the base cover and the top cover in the direction
as shown.
9.See jumper settings in Appendix N and adjust accord-
ing to your require and proceed with assembly.
Assembly
10. Slide the base cover onto the top cover with the slide
reference sitting on the lower side of the top cover.
11. Make sure you clear the RJ45 connectors with the
top cover.
VSI-Pro Max POS / Cash Register Interface
VSI-Pro Max Case Disassembly / Assembly
12. Press onto the base rear cover to align the RJ45
connectors to the the square opening on the side of the
top cover.
13. Place the base cover assembly with the base facing
upwards onto the table. Reinstall the 4X M3 x L5mm
screws and tighten.
14. Reinstall the front cover and screw in the 2X M3 x
l5mm screws which secure the front panel cover.
103