Manage Certificates For Https Access - NETGEAR GS316EP User Manual

Note: You can download SSL certificates only when HTTPS is disabled.
To configure the HTTPS access settings:
1. Open a web browser from a computer that is connected to the same network as the
switch, or connected directly to the switch through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
A login window opens.
3. Enter the device management password.
The password is the one that you specified the first time that you logged in. The
password is case-sensitive.
The HOME page displays.
4. Select SETTINGS > WEB ACCESS > HTTPS CONFIGURATION.
The HTTPS Configuration page displays. Set the following options.
5. Click the Admin Mode button to enable or disable remote access via HTTPS.
When this setting is enabled, the button displays on the right side of the slide, and
the slide turns green.
6. In the HTTPS Port field, type in the number of the port.
The default is port 443, or you can set a number in the range from 1025 to 65535.
7. In the HTTPS Session Timeout (Minutes) field, type the number of minutes that a
session can be inactive before it times out.
The default is 30. The range is 0 to 60.
8. In the Maximum Number of HTTPS Sessions field, set the number of concurrent
sessions allowed.
The default is 4. The range is 1 to 4.
9. When your settings are complete, click the APPLY button.
Your settings are applied.

Manage certificates for HTTPS access

You can manage certificates for HTTPS access. After you generate and install a valid
certificate, browser security messages no longer display.
Note: HTTPS must be disabled before you can generate a certificate. For more
information, see Configure HTTPS access settings on page 78.
Maintain and Monitor the Switch
Gigabit Ethernet Plus Switches
79 User Manual