Toshiba e-STUDIO2000AC Operator's Manual page 101

8.Install Disc
 If your TOSHIBA MFP is not found
If your TOSHIBA MFP is not found, you must first install the printer driver by temporarily selecting a local port and then
configuring the Raw TCP/LPR port.
6
Select "LPT1" in [Printer Port] and click [Install].
7
Click [Open Printer properties].
8
For the subsequent steps, refer to the Software Installation Guide.
9
Click [Finish].
 The Installer may ask you to restart your computer. If it does, select "Yes, I want to restart my computer now."
and click [Finish] to restart your computer.
 You can set the printer driver and print settings which are required in order to perform test page printing or
normal printing from this equipment. Click the buttons shown below to set them as needed. Setting can be
made even after [Finish] has been clicked.
- Show the readme file: When you select this check box, the Readme file is opened after [Finish] is clicked.
- [Open Printer Preferences]: The [Printer Preferences] dialog box of the installed printer driver is
displayed.
For details about the setting, refer to the Printing Guide.
- [Print Test Page]: Print the test page from this equipment.
- [Open Printer Properties]: The [Printer Properties] dialog box is displayed.
For details about the setting, refer to the Printing Guide.
Installing the printer drivers by using the individual installers 101