Unmount The Ssr1200 Chassis; Remove The Ssr1200 From A Rack - Juniper SSR1200 Hardware Manual

Hide thumbs Also See for SSR1200:

Table of Contents

2. If the power supply slot has a cover panel on it, remove the cover panel. Save the cover panel for

later use.

3. Taking care not to touch power supply pins, leads, or solder connections, remove the power supply

from the bag.

4. Using both hands, place the power supply in the power supply slot on the rear panel of the SSR1200

and slide it in until it is fully seated and the ejector lever fits into place. You will hear a distinct click

when the power supply is fully seated in the chassis.

Figure 16: Installing an AC Power Supply

5. Connect the power cord (see

Unmount the SSR1200 Chassis

IN THIS SECTION

Remove the SSR1200 from a Rack

Before removing an SSR1200 from a rack:

Here's what you'll need to remove the SSR1200 from a rack:

• Two people. One to hold the SSR1200 while the other one removes the screws.

"Connect SSR1200 to Power" on page

30).

Table of Contents