Juniper SSR1200 Hardware Manual page 54

• Screwdriver appropriate for your rack-mounting screws.
NOTE: When you remove multiple devices from a rack, remove the device at the top of the rack
first and proceed to remove the rest of the devices from top to bottom.
• Read "General Safety Guidelines and Warnings" on page
• Power off the SSR1200 (see
• Disconnect the power cords.
• Ensure that you have disconnected any cables or wires attached to the SSR1200.
To remove an SSR1200 from a rack:
1. Have one person support the weight of the appliance while another person uses the screwdriver to
remove the screws that attach the front mounting brackets to the rack.
2. Remove the SSR1200 from the rack.
3. Use the screwdriver to remove the screws that attach the rear mounting blades attached to the rear
of the rack.
4. Place the removed screws and rear mounting blades in a labeled bag. You will need them when you
reinstall the chassis.
"Power Off the SSR1200" on page
56.
33).
48