Kyocera FS-C5025N Supplementary Manual page 97

Configuration Using ftp
IPFILTER4 Start Address
IPFILTER4 End Address
IPFILTER4 Protocol
IPFILTER5 Start Address
IPFILTER5 End Address
IPFILTER5 Protocol
! Note: The Admin password is not written to the config file for security reasons, however, the Admin password can be
set using the config file by eliminating the semicolon and entering a password string, for example:
Admin Password = "mypassword"
Step 2 - Modify the Configuration File
All but the desired IP Filter settings are removed from the sample config file. In this cloning example the settings are not
modified, instead they are copied from one IB-23 to another. However, it is also possible to edit the settings in the config
file and write it back to the source IB-23 and thereby change its settings.
! Note: The config file can be used to create new settings, e.g. add new IP Filters, or to overwrite existing settings, e.g.
remove or modify existing IP Filters.
;;; IP Filter ;;;
IPFILTER1 Start Address
IPFILTER1 End Address
IPFILTER1 Protocol
IPFILTER2 Start Address
IPFILTER2 End Address
IPFILTER2 Protocol
IPFILTER3 Start Address
IPFILTER3 End Address
IPFILTER3 Protocol
Figure 3 shows only the remaining config file commands that will be written to the target IB-23.
Step 3 - Write the Configuration File to the Target IB-23
The procedure for writing the config file to a target IB-23 is exactly the same as the procedure for reading the file in Step 1
except command # 5 is put config rather than get config (see
file://F:\USERMAN\EXPORT\Option\IB-23\P6以降用完了分\ｈｔｍｌ\English\ftp.htm
= 0.0.0.0
= 0.0.0.0
= ""
= 0.0.0.0
= 0.0.0.0
= ""
Figure 2. Sample Config File (first 50 lines)
= 10.10.10.1
= 10.10.10.10
= "LPD, FTP, IPP, HTTP, SNMP, RAW Port"
= 10.10.10.1
= 10.10.10.30
= "LPD, IPP"
= 10.10.10.30
= 10.10.10.50
= "LPD, FTP, IPP, HTTP"
Figure 3. Modified Config File
Figure 1).
3/5 ページ
2006/05/26