Kyocera FS-C5025N Supplementary Manual page 28

Windows Printing: TCP/IP
5. Change the port name if desired. The default name given as the 'IP address_9100'.
6. Click Next. Confirm the configuration.
7. Click Finish. The TCP/IP port is created in Windows and KPrint quits automatically.
8. Proceed to Installing the Printer in Windows
Installing the Printer in Windows 98/Me
After you have successfully created a KPrint port in Windows, you are ready to point the printer driver to print to the port.
Before proceeding, make sure that:
The IB-23 is installed in the printer properly and the printer is powered up. To install the interface card, see
Installing the IB-23 Network
The appropriate printer driver has been installed. To install the printer driver, see
The procedure for creating the KPrint port has been followed properly. Review
Printing.
1. If you have not already done so, install the printer driver for the printer. For details, see
Drivers.
2. Select Windows Start, Settings, and Printers.
3. In the Printers folder, right click the printer driver that will be used to print to the TCP/IP port and select
Properties.
4. Click the Details tab. Click the pull-down menu for Print to the following port and select the TCP/IP port you
have created above.
5. Click OK.
To print from an application, select the printer driver in the application's Print menu. The printer driver
allows you to fully utilize the software and hardware features of the printer.
Top of page
file://F:\USERMAN\EXPORT\Option\IB-23\P6以降用完了分\ｈｔｍｌ\English\windows_printi...
Figure 3. Destination Printer Port Name
98/Me.
Card.
4/4 ページ
Installing the Printer Drivers.
Creating a KPrint Port for TCP/IP
Installing the Printer
2006/05/26