Kyocera FS-C5025N Supplementary Manual page 6

Installing the IB-23 Interface Card in the Printer
This section guides you through installing the IB-23 network interface card. The IB-23 can easily be installed in the
printer.
! Note: IB-23 installation is not necessary for many Kyocera Mita printer models that include a built-in IB-23 interface.
Installing the IB-23 in the Printer
WARNING: Be sure to turn off the printer before installation. Damage to both the printer and the IB-23 may result
if the following procedure is followed while the printer power is on.
IMPORTANT: To avoid damaging the IB-23 owing to static electricity, discharge your body before touching the
interface card. Hold the IB-23 only by the metal connector plate.
The instructions below describe the installation of the IB-23 into a typical Kyocera Mita printer and are similar to all
Kyocera Mita printers and digital copiers that are incorporated with the standard KUIO (Kyocera Universal I/O) slide-in
interface.
1. Turn printer power off and unplug the AC power cable from the printer.
2. At the back of the printer, remove the cover by unscrewing the two screws. Retain this cover for future re-use.
3. Insert the IB-23 into the slot aligning both edges of the card with the guides in the slot. Push the IB-23 all the way
into the slot and secure it using the screws.
file://F:\USERMAN\EXPORT\Option\IB-23\P6以降用完了分\ｈｔｍｌ\English\install_NIC.htm
Installing the IB-23 Interface Card in the Printer
1/2 ページ
2006/05/26