Table of Contents
Advertisement
66-2
Purpose
Data clear
Function (Content)
Used to set the FAX soft switch setup to the
default. (Except for the adjustment values)
Section
Fax
Item
Data
Operation/Procedure The current set value of SW1 is displayed.
Entry of 1 - 8 only is effective.
1) Specify the bit to be changed (highlighted)
with a number.
2) Select the country code, and press START to
rewrite the setting.
3) Select a number (1 - 2) with 10 digit key pad
and press START to execute.
1: FAX soft SW clear
4) The soft switch (excluding the FAX adjustment
value) corresponding to the selected country
code is cleared.
5) The selected country is highlighted.
SIMULATION 66-2
FAX SOFT SW.CLEAR (WIHTOUT ADJUSTMENT VALUE).
INPUT COUNTRY CODE, AND PRESS START.
Press [START] key.
SIMULATION 66-2
FAX SOFT SW. CLEAR.
ARE YOU SURE?
JAPAN
1:YES
2:NO
<Country codes>
Japan
U.S.A.
Australia
U.K
France
Germany
Canada
Netherlands
*
The codes other than the above are recognized as Japan.
*
Conforms to Advisory Document T.35.
2: Not clear
1 2 3 4 5 6 7 8
00000000
1
0
10110101
1001
10110100
111101
100
100000
1111011
AR-M350 SIMULATIONS 10-61
66-3
Purpose
Operation test, check
Function (Content)
Used to check the operations of FAX PWB
memory (read/write).
(This adjustment is required when replacing the
PWB with a new one.)
Section
Fax
Item
Data
Operation/Procedure Check the FAX PWB memory.
When this simulation is executed, the error
occurring address or the data line is displayed.
SIMULATION 66-3
FAX PWB MEMORY CHECK.
MFP SRAM: CHECKING
MFP FLASH: NO CHECK
MFP OP. FLASH: NO CHECK
MODEM EEPROM: NG:A0010000
MODEM SRAM(G/A):NO CHECK
MODEM SRAM: NG A11
MODEM SDRAM: OK
<List of display values>
NO CHECK
CHECKING
OK
NG
<Items>
MFP SRAM (MFP control PWB)
MFP FLASH (FAX I/F PWB)
MFP OP.FLASH (FAX I/F PWB)
MODEM EEPROM (FAX PWB)
MODEM SRAM(G/A) (FAX PWB)
MODEM SRAM (FAX PWB)
MODEM SDRAM (FAX PWB)
Not checked
Checking
Check complete OK
Check error
SRAM
FLASH Memory (AR-MM9)
Advertisement
Table of Contents
