Table of Contents
Advertisement
8. Need offset? At the main window, the file size is shown at the bottom right. For
this example, the file size is 1 Mbytes or 8 Mbits. The AT25DF321 is 32 Mbits or 4
Mbytes. An offset may be needed, depending on the image size.
Refer to the Dediprog Help for details.
Figure 8.
Dediprog: SPI Flash Offset
9. Check Offset Setting: Click the arrow next to Prog, then More Options. Always
check the offset setting because the program saved the last used setting. Fill in
the Starting Address and Length (file size). If no offset required, select the option
for Program a whole file.
Figure 9.
Offset Setting
10. Program & Verify: Click Prog after save the Offset and File size. Finally, click
Verify to verify the SPI. Make sure the checksum matches.
Figure 10.
Offset Verification
11. Done: Disconnect the Dediprog cable before booting the system.
®
®
Intel
Xeon
Processor E3-1125C with Intel
User Guide
30
®
Communications Chipset 8910 Development Kit
Crystal Forest—CRB Setup
October 2012
Order No.: 328009-001US
Advertisement
Table of Contents
