Listening To An External Audio Source - Pioneer XV-DVR9H Operating Instructions Manual

Getting started
Play display 2
1
Play 3–2 0. 00. 15
DVD-R Video Chapter Time
Chapter Total
Hi-Speed Copy
Title Name : 21/11 Football match
1 Chase playback, simultaneous record/playback,
copy, disc back-up
Indicates that recording, copying or back-up is in
progress.
2 Elapsed chapter time
3 Total running time of chapter
4 Data transfer rate
Shows the current data rate being read from the disc.
5 Copy protected material (!)
Shows '!' if the playback material is copy-once protected.
Recording display
1 2
ì Rec
3 0. 00. 15
DVD-R Video 21:00 – 22:00
FINE (1h00m/DVD) Rem.
5
1 Current title number
2 Elapsed recording time
3 Timer recording start and stop times
Shows the start and stop times if the current recording is
a timer recording.
4 Remaining recording time available
Shows the amount of space left on the disc in the current
recording mode.
5 Recording mode
Shows the current recording mode (FINE, SP, LP, etc.),
and the total recording time of the disc.
Note
• When using the simultaneous play and record
feature, the display shows information for playback
only.
• During real-time copy, the copy source playback
information is displayed.
2 3 4
5
!
0. 00. 21
0. 01. 52
4.32Mbps
3 4
ABC Pr 1
Stereo
0h35m Copy Once
DVD Mode
• Data transfer rate shows the amount of video and
audio information recorded on the disc. It is not an
indication of picture/audio quality.
• The Video mode disc displays become the same as a
DVD-Video disc once the disc is finalized.
• The total recording time figure shown in parenthesis
is calculated based on a 12cm/4.7GB disc at the
displayed record setting.
• Recording and playback times for TV recordings are
approximately 0.1% shorter than the actual time. This
is because of the slightly different frame rates of TV
broadcasts versus DVD.
• The frame number is shown next to the elapsed time
display when the disc is paused.
• Copy Once or Can't Record messages may appear
in the stop or recording displays. These indicate that
the broadcast TV program contains copy control
information.

Listening to an external audio source

You can connect both analog and digital external audio
sources to this system. Digital audio sources include
digital satellite receivers, CD recorders, etc. Analog
sources include tape decks and turntables (used with a
suitable phono pre-amp). See also Connecting auxiliary
components on page 121.
STANDBY/ON
1 If the system isn't already on, press
ON to switch on.
Also make sure that the external source (TV, satellite
receiver, etc.) is switched on.
2 Use the AUDIO INPUT button to select an audio
input source.
DIGITAL
ANALOG
3 If necessary, start playback of the external
source.
AUDIO INPUT
DIG/ANA
STANDBY/
03
29
En