Pioneer XV-DVR9H Operating Instructions Manual page 80

08 Editing
• Divide – Divide a chapter into two or more parts:
Select the chapter you want to divide. From the
following screen use the playback controls ( , ,
, , etc.) to find the point at which you want to
divide the chapter. With Divide highlighted, press
ENTER.
Divide Chapter
Original
DVD
Divide
Back
You can keep dividing the chapter as many times as
you wish (up to 999 chapters per DVD disc or 99
chapters per HDD title). Highlight Back and press
ENTER to return to the Chapter Edit screen.
• Combine – Combine two adjacent chapters into one:
Highlight the bar divider between two adjacent
chapters and press ENTER (see also the note below)
• Preview – Preview chapters: Select the chapter you
want to play; press
edit screen.
• Undo – Undo the last command (only works with VR
mode disc edits).
3 Press RETURN to get back to the menu options on
the left side of the screen.
4 To return to the Disc Navigator screen, press
RETURN again, or select 'Back' from the menu
options on the left.
Note
• When editing VR mode Original content, it may not
be possible to erase chapters less than five seconds
long.
• It may not always be possible to combine two
chapters, even though they are adjacent. If a chapter
has been divided into three, then the middle chapter
erased, it is not possible to combine the two
remaining chapters into one.
80
En
Title 15:00 Wed 13/12 Pr 5 LP Chapter
1 Recording Time 0h01m24s
1-3 0.00.52.17
Play Pause
Divide
STOP to return to the chapter
Erase Section (Erase Sec)
VR mode
Using this command you can delete a part of an Original
title, ideal for cutting out the commercial breaks in a
recording made from the TV.
1 Select 'Erase Sec' from the Disc Navigator menu
options.
2 Use the
0h00m
title.
After selecting a title, the Erase Sec screen appears from
which you can mark the start and end points of the
section to erase.
3 Use the playback controls ( , ,
find the start of the section to erase, then (with
'From' highlighted) press ENTER.
The bar at the bottom of the screen shows the current
play position in the title. After pressing ENTER, a marker
appears under the bar to show the start of the section.
4 In the same way, find the end of the section to
erase, then (with 'To' highlighted) press ENTER.
After pressing ENTER, another marker appears under the
bar to show the end of the section, with the section itself
marked in red.
5 Select 'Yes' to confirm, or 'No' to cancel, then
press ENTER.
In the thumbnail viewer you can see a few seconds of
video either side of the marked section to see how the
edit will look.
• When editing VR mode Original content, you may not
be able to erase very short sections (less than five
seconds).
HDD
(cursor buttons) to select a
Erase Sec
Original
DVD
15:00 Wed 13/12 Pr 5
Title 1
Recording Time
1-1
Play Pause
A
Erase Sec
From
Back
Play Pause
A
From
0.02.09.17
A
LP
0h01m24s
0.00.52.17
B
To
, , etc.) to
B
T