Pioneer XV-DVR9H Operating Instructions Manual page 130

17 Additional information
Problem
Can't play a disc recorded using this
system on another player
Screen is stretched vertically or
horizontally
The picture from the external input
is distorted
During playback the picture is dark
or distorted
The picture freezes and the front
panel and remote control buttons
stop working
No sound is output when a function
is selected.
No sound from surround or center
speakers.
Remote control does not work
Sound Demo shows in the display
and controls are inoperative.
Can't control your TV using this
remote control
After briefly unplugging or after a
power failure the front panel dis-
play shows '--:--'
Screen goes black and controls are
inoperative
130
En
Remedy
• If the disc was recorded in Video mode, make sure that it's finalized (page 58).
•Some players will not play recordable DVD discs, even when recorded in Video
mode and finalized.
• If the disc was recorded in VR mode, the other player must be specifically RW
compatible in order to play it (page 10).
• Discs recorded with copy-once material cannot be played on non-CPRM
compatible players (page 45).
• Make sure that the TV Screen Size setting (page 112) is correct for the kind of TV
you have (see also page 128).
• If you have a widescreen TV, check its aspect ratio settings.
• This system's input switches into wide mode automatically according to the
input signal. When the unit connected is not compatible with VIDEO ID-1
(widescreen signaling), set the connected component to output 4:3 aspect ratio
(standard) video.
• If the video signal from the external component is copy-protected, you cannot
connect via this system. Connect the component directly to your TV.
• When a copy-protected disc is played via a VCR, the picture will not display
correctly. Connect the system directly to your TV.
• Press the front panel STANDBY/ON button to switch the power off, then
switch back on and restart playback. If the power fails to switch off, press and hold
STANDBY/ON for 10 seconds until the power switches off.
• If you're using the external input, make sure the component is connected
correctly (see Other connections on page 115).
MUTE
• Press on the remote control to turn muting off.
VOLUME
• Adjust the .
• There is no sound when the picture is paused, or during scanning or slow
motion play. Press PLAY to resume regular playback.
• Refer to Setting the channel levels on page 95 to check the speaker levels.
• Check that you haven't selected the STEREO sound mode, or the AUTO mode (if
a stereo source) (see Listening with home theater sound on page 30).
• Connect the speakers properly (refer to the Setup Guide).
• If you connected this system to another Pioneer product using the CONTROL IN
jack, point the remote control at the other component to use (page 10).
• Use the remote within its operating range (page 10).
• Replace the batteries (page 9).
• Avoid exposing the remote sensor on the front panel to direct light.
STOP on the front panel for about five seconds. The disc tray
• Press and hold
ejects automatically to indicate the Sound Demo mode is disabled.
• If there is more than one code listed for your make of TV, try each one in turn
(page 124)
• It is possible that none of the codes listed will work with your particular model of
TV, even if the maker appears in the remote control code list.
• A backup battery keeps the clock and other settings from being reset when there
is no power to the system. This battery should last approximately five years from
factory shipping.
Reset the clock and other system settings to use the system again. To have the
battery replaced, contact your dealer or a Pioneer Service Center.
STOP then restart playback.
• Press