Zenith HydroTap G5 Installation Instructions Manual page 25

13.5 Tank flush
• Follow the instructions to flush the tanks.
Dispense water from the tap if instructed.
• Note The 'Auto Dispense' option will be
enabled/disabled based on the selection
made in the drain away option screen.
It can be altered by touching the toggle
button.
• Note Care should be taken if enabling
'Auto Dispense' if the tap drains over a font
as it may overfill during the tank flush.
• Make a selection and press Run to start
the tank flush.
• If 'Auto Dispense' is enabled the tanks will
fill and empty automatically except if the
water in the hot tank is above 50°C. In this
case follow the prompts on the screen
to utilise the tap and its safety feature to
empty the hot tank.
• If 'Auto Dispense' is disabled the tanks will
fill automatically. When prompted use the
tap to dispense water and empty the tanks.
If the hot tank has water above 50°C then
use the taps safety feature to dispense.
13.6 Boiling calibration
• Press the green button and the system will
start the boiling calibration procedure.
This can take up to 10 minutes.
Quick Start Installation Guide
807042NZ v1.02 08.22 HydroTap G5 UltraCare Install Instructions
SECTION 13: Commissioning
(does not apply to chilled sparkling models)
TANK FLUSH
Fresh water will be flushed through the
tank/s multiple times as shown by the cycle counter/s.
Enabling 'Auto Dispense'fill/empty
the tank/s automatically.
Toggle to manually dispense from the tap.
If prompted dispense water from the hot tank
using the taps safety feature.
BC Models
TANK FLUSH
Hot Tank
Cycle 0/2
98.0 °C
Auto
Dispense
BOILING CALIBRATION
Boiling Water Temp.
88.0 °C
Steam Vent Temp.
80.0 °C
Element Power %
0
12:12
12:12
Cold Tank
Cycle /3
Run:
12:12
Water tank is filing
Safety
Hot
25