Zenith HydroTap G5 Installation Instructions Manual page 24

13.4 Filter flush
• Follow the steps on-screen to flush the
filter.
• Open filter door & uncoil flush line.
• Direct flush line into bucket.
• Place a cloth or towel under the filter
cartridge to catch any water that may
spill.
• Open the stop cock valve.
• Start filter flush.
FILTER FLUSH
STEP 1.
Open the filter access door and turn the flush line
STOP COCK VALVE to the ON position.
STEP 2.
Place a 10L bucket under the flush line valve to catch
the water flushed through the filter.
FILTER FLUSH
RUNNING.....
Water is now being flushed through the filter.
This process is automatic and will take 2 minutes.
Press pause to pause filter flush.
FILTER FLUSH
FILTER HAS BEEN FLUSHED!
Turn the flush line STOP COCK VALVE
back to the OFF position
Your filter has now been flushed and is ready to use.
You will need to check the life span of the filter
in filter settings
• Once the filter flush is finished, close the
stop cock valve .
• Wipe up any spills.
• Close the door to secure the appliance.
Quick Start Installation Guide
24
807042NZ v1.02 08.22 HydroTap G5 UltraCare Install Instructions
SECTION 13: Commissioning
12:12 PM
12:12
| |
12:12 PM
Stop cock valve open
Stop cock valve closed