Zenith HydroTap G5 Installation Instructions Manual page 21

SECTION 12: Connect the Command Centre
UV-C Module
• Connect chilled water hose to UV-C
module.
Push hose at least 15mm over the fittings.
• Ensure that the hose has a constant fall.
• Insert UV-C module into the port marked
CHILLED OUT.
Do not switch on the Command
!
Centre electricity supply until
commissioning the system
• Plug USB cable from UV-C
module into the port at the
side of the Command Centre.
• The USB cable can be inserted either
direction (no polarity).
• Plug the 12V UV-C module power
supply into the Command Centre.
• Insert all connectors square on &
firmly in place.
• Do not apply off axis or lateral force to
the connections.
UV-C Power supply & bracket
!
Use only the power supply provided
• Connect the UV-C power supply to the power outlet
• Ensure the self adhesive L-shaped bracket (supplied)
is fitted in position, this will
protect the power supply from
accidental disconnection.
807042NZ v1.02 08.22 HydroTap G5 UltraCare Install Instructions
Chilled water
hose
Self adhesive
L-shaped bracket
UV-C
module
UV-C
power supply
21