Troubleshooting; Access Codes - Clarity Walker W-1000 User Manual

Programming Personal

Access Codes

• Difficulty Programming
Account Numbers
—Your TONE/PULSE selector must be
switched to the TONE mode to enter
account numbers. This is because most
interactive phone systems require
TOUCH TONE to operate. If your
phone service is rotary service, you
must have the switch set to PULSE to
dial a number. Once you are connected
move the switch to TONE and enter
your responses using TOUCH TONE
mode. When your call is complete move
the switch back to PULSE so you are
ready to make your next call.
Static On Line
• Interference From
Household Appliances
—Your Clarity phone may be located
near a touch lamp, microwave or
W-1000
W1000_User_Guide

Troubleshooting

Continued
21
refrigerator which may cause interfer-
ence. Relocating your phone to another
area may eliminate the problem.
—A cordless phone on your phone
line may also cause static. Try discon-
necting your cordless phone for several
days. This may eliminate the problem.
• Interference From
Malfunctioning, Frayed Or
Poorly Connected
Telephone Cords
—Check your phone cords and con-
nections. Try interchanging cords with
another phone. Replace any defective
equipment.
Feedback Problems
• Feedback Occurs When
Handset Is Set Down
—Avoid setting receiver on a hard
surface or attach a foam receiver pad to
earpiece of phone. You can also lay the
receiver on its side. This will eliminate
feedback also.
11/15/99, 9:38 PM
E
N
G
L
I
S
H
Page 21