Clarity Walker W-1000 User Manual page 16

E
3. Pick up the handset from the phone
N
base, press and release the "PROGRAM"
G
button on the base unit.
L
I
4. Dial the number you wish to store.
S
The number is not transmitted while
you are programming it. You can
H
program a pause into the dialing
sequence, if necessary. Since there is not
a separate pause button on the phone,
the redial button serves this purpose
during programming. Remember, you can
store up to 15 digits and the pause
function counts as 1 of those digits.
Note: Programming in the pause
function will cause the phone to
wait 3 seconds before dialing any
more numbers. For example:
Pressing a memory button that
has 9<P>555-1212
programmed into it will dial the
number 9, then wait 3 seconds
and dial 555-1212. In most
cases, you will not need to use a
pause.
5. Press the "PROGRAM" button again,
and then the appropriate Emergency
Button.
Page 16
W1000_User_Guide
Programming
Continued
16
6. Repeat steps 3, 4, and 5 for the other
two Emergency Buttons.
7. Place handset back into cradle.
To Dial Programmed
Emergency Number:
1. Pick up the handset and listen for a
dial tone.
2. Press the appropriate Emergency
Button.
3. The number will be dialed
automatically.
Important: The
emergency buttons are
not preprogrammed for
911. You must do this
yourself. Use a preprinted
911 label and paste it
over the button you
program for 911. Use
other write on labels to
identify any numbers you
wish to program into the
two remaining emergency
buttons.
11/15/99, 9:38 PM
W-1000