Table of Contents
Advertisement
E R R O R
M E S S A G E S :
Cannot open configuration file Flash.cfg – when the Flash Tool starts, it
needs the Flash.cfg configuration file. The full path of the missing file is
displayed. Check if you have correctly installed the Flash Tool. Note:
this file has nothing to do with the "-cfg" command line switch !
Cannot load file "config\FlashTool\KernelBoot.abi" from disk! – the
kernel which is downloaded into the target system is not found. Check if
you have correctly installed the Flash Tool.
For mixed mode the internal Flash and the external Flash cannot be in
the same address range - Overlap of CPU and external FLASH is not
allowed combination, because is not clear which memory should be
programmed.
Warning! Code outside of selected FLASH range – the user code is
linked to adressess which are outside of the selected FLASH, this code
cannot be burned. Set the right FLASH or recompile program to correct
addresses.
The abs file has been compiled for ‚internal FLASH'– the user code is
prepared for running in internal FLASH, but different mode is selected.
Set the right mode.
The abs file has been compiled for ‚external FLASH'– the user code is
prepared for running in external FLASH, but different mode is selected.
Set the right mode.
The abs file has been compiled for ‚mixed mode' – the user code is
prepared for running in mixed mode (internal and external FLASH), but
but different mode is selected. Set the right mode.
Error in communication - disconnected cable, COM port occupied by
another program, etc.
MCU busy - the DevKit16 is busy and cannot download kernel into the
RAM.
Command error - the BI-Rom doesn't support downloading into the RAM
Writing error - error while writing
Time out - the DevKit16 BI-ROM is not responding
Bad checksum - bad checksum of data – the communication cable is
possible damaged or unstable
Unknown error - unexpected error during communication
36
36
36
36
Advertisement
Table of Contents
