Table of Contents
Advertisement
E.g., when burning Fujitsu debug monitor or PE debug kernel, select the
"Base address FC0000" option.
Note: special care must be taken when burning a mixed mode
application. In mixed mode, both internal and external FLASH
memories are accessible in the MCU memory space. With the "external
FLASH 200BC - Base address FC0000" option, the internal FLASH
memory space overlaps a part of the external FLASH memory. In this
case, Flashtool is unable to distinguish which FLASH should be actually
burned in the overlapped area. Therefore, user should always leave the
"external FLASH 200BC - Base address F80000 (mixed mode)" option
ON when burning a mixed mode application. (For further details about
Devkit16 and its memory maps see the UserGuideDevkit16.PDF manual,
chapter "Mainboard Programmer's Reference".
• Now, you can click on the button „Connect "
• Flashtool is now ready to start the desired operations
N E C E S S A R Y
D E V K I T 1 6
• PC must be connected to the Devkit16 USER UART connector.
• The J1 jumper must be in the 2-3 position (the PE debugger position)
and all the other jumpers must be placed according to Figure 2 on page
77
• The mainboard System configuration DIP switches must be set to
"Serial FLASH Programming mode", UART1 and 8 bit ext. FLASH
access:
• FPGA must be enabled – the J29 jumper must be opened.
• Now, reset system using the RST button
H O W
T O
B U R N
Using FlashTool
Set up the Flashtool controls and Devkit16 according to the previous
paragraph.
Click on button „Open *.abs" and open the compiled project
M A I N B O A R D
ON
1
2
3
4
5
U S E R
P R O G R A M
31
31
31
31
H W
S E T T I N G S
6
7
8
I N T O
T H E
F L A S H
Advertisement
Table of Contents
