Table of Contents
Advertisement
Progress - Current state of running action.
C O M M O N L Y
U S E D
• If you want to burn Softune debug monitor or PE debug kernel, please
check the paragraph "How to burn the Softune debug monitor" (or
"How to burn PE debug kernel", respectively) first. In these paragraphs,
there is a description of a non-interactive mode of the Flashtool that can
be very useful when you need to burn these programs frequently.
However, if you want to burn these programs interactively, continue
reading this section.
Note: Prior to the Flashtool version 1.1, there used to be a special
command line option "
Flashtool.exe for burning the Fujitsu debug monitor. Even though this
command line was encapsulated in a flash tool configuration file (*.ftc)
so it was hidden to most of the users, in Flashtool 1.1 and higher
versions this command line is not needed anymore. If you have any
version of Flashtool prior to the 1.2, you can download the latest
Flashtool installation package from the PE Web site.
• If you use standard Devkit16 (CPU board in connection with
Mainboard) without any additional HW, that could cause the AD bus
contention, set the "External bus free" radio button to "Yes" in
Flashtool. If you use a standalone CPU board with a RS-232 adaptor on
the K7 connector or an additional HW, that could cause the AD bus
contention, set the "External bus free" radio button to "No". In this case,
the communication speed will be limited to 9600 Bd.
• Select which FLASH will be programmed (internal, external or both in
case of a mixed mode application). E.g., when burning Fujitsu debug
monitor or PE debug kernel, "external FLASH" must be chosen.
• Set the right COM port where you have a serial cable connected to
DevKit16
• Set the CPU frequency
• Select required location of the Mainboard FLASH according to your
project settings. The possible choices for external FLASH mode or
mixed mode are:
1. external FLASH 200BC - Base address FC0000
2. external FLASH 200BC - Base address F80000 (mixed mode)
3. external FLASH 200BC - Base 100000
S E T T I N G S
O F
", which had to be used to run the
-move 13 ff
30
30
30
30
T H E
C O N T R O L S
Advertisement
Table of Contents
