Analog Option Board For N -Type Cpu Units - Omron SYSMAC CP Series User Manual

3 Part Names and Functions
3-1-5 Analog Option Board for N
The Analog Option Board can be used for a CP2E N
N -type CPU Units
CP1W-ADB21
Analog Input
Option Board
Note Maximum one Analog Option Board can be mounted on an N
If two Analog Option Boards are mounted, an option board error will occur and both Analog Option Boards
do not work.
Analog Option Board
Analog option board units are non-isolated analog units which allow you to easily realize analog
input/output function for CP2E N
Analog Option Board
Analog I/O Option Board
Analog Input Option Board
Analog Output Option Board
How to Mount an Analog Option Board
When mounting an Option Board, first remove the slot cover.
Press the up/down lock-levers on both sides of the Option Board slot cover at the same time to
unlock the cover, and then pull the cover out.
Check the alignment to make the corner cut of the Option Board fit in the Option Board slot, and
firmly press the Option Board in until it snaps into place.
Precautions for Correct Use Precautions for Correct Use
Always turn OFF the power supply to the PLC before mounting or removing an Option Board.
Not doing so may result in an unexpected operation.
3-24
-type CPU Units
CP2E N -type
CPU Unit
CP1W-DAB21V CP1W-MAB221
Analog Output Analog Input/Output
Option Board Option Board
-type CPU Unit.
Voltage Input
CP1W-MAB221 2CH
CP1W-ADB21 2CH
CP1W-DAB21V ---
-type CPU Unit.
-type CPU Unit.
Current Input
0V~10V 0mA~20mA
(Resolution: (Resolution:
1/4000) 1/2000)
CP2E CPU Unit Hardware User's Manual(W613)
Voltage Output
0V~10V
(Resolution:
1/4000)
2CH
---
2CH