Memory Cassette Transfer (Cp-Series Cpu Units Only) - Omron CJ - REFERENCE MANUAL 07-2009 Reference Manual

FINS Commands

5-3-43 MEMORY CASSETTE TRANSFER (CP-series CPU Units Only): 22 20

User program
Parameter area (PLC Setup, CPU Bus Unit set-
tings, and routing tables)
Symbol table
Comments (I/O comments, row comments, and
annotations)
Program indices (section names, section
comments, and program comments)
Function block sources
Data memory
Data memory initial values
Execution Conditions
Command Format
Response Format
Parameters
Transfers or verifies data between a Memory Cassette mounted in a CP-
series CPU Unit (see note) and the memory areas in the CP-series CPU Unit.
Transfers can go either direction.
Note This command is supported only by CP-series CPU Units (Except CP1E CPU Units).
Applicable data
Access right at
other device
No
RUN mode
No
Note Data cannot be transferred from the CPU Unit to the Memory Cassette when
the user program is included and DIP switch UM protection is set.
22 20
MEMORY
Disk number
CASSETTE
TRANSFER
Other Memory Cassette Operations (Parameter ≠ 8000 Hex)
22 20
MEMORY
End code
CASSETTE
TRANSFER
Reading the Data Type in the Memory Cassette (Parameter = 8000 Hex)
22 20
MEMORY
End code
CASSETTE
TRANSFER
Disk number (command)
Specify the disk for transfer or verification. Only the Memory Cassette can be
specified.
8003 (hex): Memory Cassette
Storage location in CPU Unit
RAM (user program area)
RAM (parameter area)
Built-in flash memory (Comment Memory Area)
Built-in flash memory (Comment Memory Area)
Built-in flash memory (Comment Memory Area)
Built-in flash memory (Function Block Source Memory
Area)
RAM (DM Area D0 to D32767)
Built-in flash memory (Data memory initial value area)
UM read DIP switch UM write
protection protection
OK OK (See note.)
MONITOR mode
No
Parameter Data type designation
Stored data type
Section 5-3
Network write
protection
No
PROGRAM mode
OK
227