Touchscreen Profiles; Led Activity Indicators - Juniper Mesa Pro User Manual

Hide thumbs Also See for Mesa Pro:

Table of Contents

2.3.3 Touchscreen Profiles

To adjust the touchscreen profile, go to Device Settings and

select Touchscreen. Select the touch profile you want the screen

optimized for: Finger/Stylus (default), Finger, Fine Hard-Tip Stylus,

Glove, Wet/Finger, or Wet/Stylus. As the new profile loads, a

progress bar is shown. You can try different profiles to see which

one works best.

Using the Mesa Pro in Wet Conditions

When using the Mesa Pro in wet conditions, you must use your

finger or the fine-tipped stylus that is included with the device

on the capacitive touchscreen, depending on the touchscreen

profile you have selected. When either of the Wet touchscreen

profiles are in use, the Mesa Pro must be held at a minimum 30

degree angle. While third party styli may work with the Mesa Pro

touchscreen, performance may vary.

CAUTION: Do not use the Windows 11 screen calibration tool. If

used, it may degrade the touchscreen performance.

LED activity indicators are located on the front of the Mesa Pro in

the upper-left corner.

Red LED, solid:

■

When the Mesa Pro is put to sleep or powered off by

pressing the power key

has successfully completed the process, and then the red

LED turns off. If powering off the device, do not remove the

batteries while the light is solid.

, the red LED is solid until the unit

2 Standard Features

Table of Contents