Table of Contents
Advertisement
3. Insert the battery packs.
a. Hold the battery so the black tab on the back edge of the
battery and connector is facing the door latch.
b. Place the front edge in first, gently pushing it underneath
the two battery catches.
c. Rotate the back of the battery down until it sits flat inside
the battery compartment.
CAUTION: Do not insert the battery pack straight down.
!
Damage to the unit could occur.
4. Replace the door and press down on it while sliding the latch
into the lock position.
5. Attach the appropriate plug for your country into the AC wall
charger and plug it into a wall socket. Plug the other end into
the DC power jack on the Mesa Pro.
Note: Use the AC wall charger that came with the Mesa Pro or
another approved charger from Juniper Systems. If you use a
USB-C charger ensure it can deliver 20 V with a minimum of 60
Watts.
6. Charge the battery packs at room temperature (68°F or 20°C)
until fully charged.
While the battery packs are charging, the red LED blinks. When
batteries are fully charged and external power is applied, the red
LED is solid.
The battery packs can also be charged in the battery charger. This
is an optional accessory that allows you to charge extra batteries
outside of the Mesa Pro.
10
Mesa Pro Rugged Tablet User's Manual
Advertisement
Table of Contents
