Attach The Stylus Tether - Juniper Mesa Pro User Manual

To attach the hand strap, fasten it to three corners as shown in
the pictures below.

1.3.5 Attach the Stylus Tether

A fine tip capacitive stylus and tether are included with the Mesa
Pro. To attach the stylus tether:
1. Remove the stylus by pressing on one end of the stylus until it
releases.
2. Attach one end of the stylus tether to the stylus.
3. Push the free tether loop through the tether attachment
point located on the bottom right side of the Mesa Pro.
4. Insert the stylus with the attached tether through this loop
and tighten the loop.
5. Place the stylus into the stylus storage slot located on the
back side of the Mesa Pro by lining up the notched end of the
stylus with the stylus catch on the Mesa Pro.
12
Mesa Pro Rugged Tablet User's Manual