Table of Contents
Advertisement
1997 Guitar Regional Training
ROLAND GR-30
HANDS ON
I
NITIALIZING THE
You can return the GR-30 to its original factory settings for the Program Numbers,
System Parameters, Patches, or ALL Data by re-initializing the unit.
1)
Turn the GR-30 ON while pressing PEDAL 2.
2)
Press PATCH [+] to select the type of initialization. "Pgo" initializes the MIDI Program Numbers, "Pat" ini-
tializes Patches, "Sys" initializes System Settings, and "ini" initializes all data.
3)
Press EDIT/PLAY.
4)
Press PATCH [+] and [-] buttons simultaneously.
S
S
ETTING
Setting the string sensitivity is very important in order to insure accurate tracking. To perform properly, each string
should be adjusted so that it is not too hot or too weak in amplitude.
1)
Use the Dial on the right hand side of the GR-30 to select PICKUP SENS (1-6).
2)
Press the EDIT/PLAY button.
3)
Play a string fairly hard. The number to the left of the display is the string num-
ber, and the number to the right is the level of sensitivity.
4)
As you play the string, the meter to the left of the display will show the level of sensitivity. Use the [+] or [-]
buttons to adjust the level so that only the green lights appear. If the red light appears then the sensitivity is
too hot.
5)
After adjusting, press EDIT/PLAY to return to the play mode.
8
GR-30
S
TRING
ENSITIVITY
Number of string played (1 to 6)
String sensitivity setting value for the played string (1 to 8)
Advertisement
Table of Contents
