Korg drumlogue Owner's Manual page 47

nector; messages are transmitted from the USB B connector and the MIDI OUT connector.
USB: MIDI messages will be transmitted and received only via the USB B connector.
MIDI RX (Button 8)
PRG CHG (PROGRAM CHANGE)
Selects whether MIDI program change messages will be received. Turn this ON
when receiving messages.
CC (CONTROL CHANGE)
Selects whether MIDI control change messages will be received. Turn this ON
when receiving messages.
TRANSP (MIDI TRANSPORT)
A filter to receive MIDI transport messages such as MIDI start/stop. Turn this ON
when receiving messages.
MIDI TX (Button 9)
PRG CHG (PROGRAM CHANGE)
Selects whether MIDI program change messages will be transmitted. Turn this ON
when sending messages.
CC (CONTROL CHANGE)
Selects whether MIDI control change messages will be transmitted. Turn this ON
when sending messages.
TRANSP (MIDI TRANSPORT)
A filter to send MIDI transport messages such as MIDI start/stop. Turn this ON
when sending messages.
SYNC IN (Button 10)
UNIT (SYNC IN UNIT)
The Sync In Units determine how much the Sequencer will advance with each
pulse received via the SYNC IN jack.
8TH: The Sequencer will advance one eighth note for each pulse.
16TH: The Sequencer will advance one sixteenth note for each pulse.
POLAR
In order to achieve synchronization with other units, the polarity of the SYNC IN
jack may need to be changed.
RISE: The drumlogue will sync to the pulse as it rises to its crest (the highest point)
of the waveform.
FALL: The drumlogue will sync to the pulse as it falls to its trough (the lowest
point) of the waveform.
[OFF, ON]
[OFF, ON]
[OFF, ON]
[OFF, ON]
[OFF, ON]
[OFF, ON]
[8TH, 16TH]
[RISE, FALL]
47